PATON StandardCUT-45 MAXflow plasma cutter
The inverter plasma cutter Paton StandardCUT-45 MAXflow is made for manual cutting of metals and alloys with a plasma arc in an air jet, and it cuts with high precision in metals of varied structure and of thickness up to 10mm. The cutter from the "Standard" series runs on a single phase 230V supply and puts high power together with easy handling and a small footprint. The machine suits private workshops as well as professional ones.
The built in compressor means no separate source of compressed air is needed, and the cutter is also easy to set up and use, compact and convenient to handle.
Key features and advantages of the PATON StandardCUT-45 MAXflow plasma cutter
-
Built in compressor, no external source of compressed air needed
With the built in compressor the unit is self sufficient, so there is no need for an external source of compressed air. That makes it easier to use, cuts costs and simplifies setup, while keeping cutting performance steady and at its best. -
Simple setup
The cutter is designed so the machine can be made ready for work quickly and intuitively. Thanks to plain instructions and a clear control panel the user can start almost at once, which saves time and reduces the risk of mistakes during installation. -
Protection against mains peak overloads
The protection system shields the unit from sudden voltage rises that can occur in the power grid. Overloads of this kind can damage the electronics or other key parts of the cutter, and the protection system keeps operation stable and extends the service life of the machine. -
Single phase connection
The cutter takes a single phase connection, which makes it easy to plug into standard sockets in most places. It is a practical solution that does not call for a special three phase installation, so the machine can be used in many different conditions. -
Higher reliability in dusty production conditions
The unit was designed for work in hard conditions such as dusty surroundings, which are typical of many production halls. Better resistance to airborne dirt, dust and other environmental factors means the cutter keeps working reliably even where demands are high. -
Every heated part has a thermal protection system
Every part of the unit exposed to heating has a built in thermal protection system. That prevents overheating, which could lead to a failure or to lower performance. The user can therefore work without worrying about damage caused by excess heat. -
Stepless current control
The cutter allows precise, stepless setting of the current to suit the user. Stepless control makes it possible to match the cutting parameters to the material and its thickness, which keeps work efficient and of high quality.
The set you buy contains:
- Plasma cutter PATON StandardCUT-45 MAXflow
- Plasma torch 4m
- Lead with an ABICOR BINZEL earth clamp 4m
- Pneumatic quick coupling
