PATON™ StandardCUT-70-400V Plasma Cutter

PATON StandardCUT-70 400V Plasma Cutter

The inverter plasma cutter Paton StandardCUT-70 is intended for manual cutting of metals and alloys with an air plasma arc, and it cuts with high accuracy in metals of varied structure and thickness up to 25mm. The cutter from the Standard series runs from a three-phase 400V mains supply and joins high power with easy handling and small overall dimensions. Because the converter frequency is raised, the machine weighs less and takes up less room than classic cutters.

The cutter is light and easy to set up thanks to stepless current adjustment, which allows precise cutting without deforming the metal, both in sheet and along a curve. The machine carries a protection system for the case of insufficient air pressure and a pneumatic system with two valves, for a gentle arc start with less metal spatter and for a longer life of the plasma torch consumables.

Main features and advantages of the PATON StandardCUT-70 400V plasma cutter

• Protection against peak overloads - This system guards the machine against damage caused by sudden, short current overloads, which adds to the working life and reliability of the cutter, even in hard conditions.

• IGBT inverter technology - Inverters using IGBT technology (Insulated Gate Bipolar Transistor) give stable and accurate operation of the machine, together with higher energy efficiency and lower power losses, which results in better cutting performance.

• Three-phase connection with no neutral conductor needed - The cutter is designed to work in a three-phase system without connecting a neutral conductor, which simplifies the installation and lowers the risk of mistakes during setup.

• Forced cooling - The cutter carries a forced cooling system that draws heat away from the key components of the machine. Long work is therefore possible without the risk of overheating, which keeps operation stable and reliable under heavy use.

• Convenient and simple handling - The cutter was designed for ease of use, and an intuitive control panel, an ergonomic build and a minimum of service work mean that handling the machine is convenient and free of trouble.

• 50% duty cycle at 70A, 100% at 40A - A duty cycle of 50% at 70A and 100% at 40A means the machine can run without a break for a longer time, which matters in heavy and long cutting jobs, while quality and efficiency of the work stay high.

• Higher reliability of the machine in dusty conditions - The cutter was optimised for hard conditions, such as a high concentration of dust or dirt, which adds to its working life and reliability and lowers the risk of failures caused by contamination.

• Thermal protection on all heating parts - The machine carries built-in thermal protection that prevents overheating in the key parts, such as the transistors or the transformer, which raises safety and the working efficiency of the cutter.

• Stepless current adjustment - Stepless adjustment gives the user full control over the current, which allows the cutting parameters to be matched precisely to different materials and thicknesses for a better result.

• Pneumatic system with a double valve - A pneumatic system with a double valve gives better control over the gas flow, which matters for cut quality and working accuracy, and it also lowers the risk of failures linked to leaks.

The purchased set contains:

• Plasma cutter PATON StandardCUT-70 400V
• ABICOR BINZEL plasma torch, 4m
• Cable with ABICOR BINZEL earth clamp 3m
• Pneumatic quick coupling