The Hypertherm Powermax G3 1250 is an air cooled plasma cutter with a cutting current of 80 A. The set holds an original Hypertherm torch 7.5 m long, an earth cable about 5 m and a supply cable 3 m.
What this machine is for
A current of 80 A is a range for structural sheet, sections, pipes and reclaimed parts in a metalwork shop or in a repair firm. Plasma cuts every material that conducts current, so apart from black steel you take acid resistant steel, aluminium and copper, which an oxygen torch will not cut. The same torch goes on thin and on thick sheet, you change only the current setting and the air pressure.
A torch 7.5 m long gives good reach around the table, and an earth cable about 5 m lets you clamp the earth at a handy place on the sheet. Powermax is a series with a simple panel: you set the current, check the pressure and cut, without going into an extended menu.
Features and equipment
- Cutting current 80 A: a range for typical workshop thicknesses in steel, acid resistant steel and aluminium.
- Air cooling: no fluid circuit, fewer parts to service.
- Original Hypertherm torch 7.5 m: you go around the sheet without moving the machine.
- Earth cable about 5 m and supply cable 3 m.
Technical data
| Brand | Hypertherm |
|---|---|
| Model | Powermax G3 1250 |
| Type | plasma cutter |
| Cutting current | 80 A |
| Cutting current given on the card | up to 130 A |
| Cooling | gas |
| Plasma torch | Hypertherm, 7.5 m |
| Earth cable | about 5 m |
| Supply cable | 3 m |
What you get
- Hypertherm torch 7.5 m
- earth cable about 5 m
- supply cable 3 m
What to watch out for
The card does not give the supply voltage, the duty cycle, the weight or the dimensions of this unit, so settle the type of socket, the size of the fuse and the way of transport with us before you buy. The air decides the result of the cut: add a dryer and a filter, because water and oil in the installation burn the nozzle and the electrode, and the edge comes out uneven. When you cut close to the upper thickness count on a slower travel and on cleaning the lower edge before welding. Prepare a stock of nozzles and electrodes, because these are wear parts. Confirm the set before collection.
This unit is sold
This machine has already gone to a customer. Similar units are listed below, and if you want the same model, leave your contact details in the form and we will let you know when the next one arrives.