Ideal Expert MIG 301 Pulse Pro7 LCD is a synergic 3 x 400 V inverter power source for MIG/MAG, self-shielded wire (FLUX), TIG LIFT and MMA welding, with single and double pulse in MIG/MAG. You use it on stainless steel, carbon and low-alloy steels and aluminium, and you can also braze galvanised sheet. It delivers up to 300 A and holds 232 A at 100% duty cycle. You set the parameters on a 7-inch LCD touchscreen, and the 4-roll feeder drives 0.8 to 1.6 mm wire.
Specifications
- Power supply: 400 V, 50 to 60 Hz, three-phase, without plug
- Mains protection: 25 A (C)
- Power: 11 kW
- Welding current range: MIG/MAG 20 to 300 A, MMA and TIG 10 to 300 A
- Duty cycle (MIG/MAG, MMA, TIG): 300 A at 60%, 232 A at 100%
- Wire feeder: 4-roll
- Steel and stainless wire: 0.8 to 1.6 mm
- Aluminium wire: 1.0 to 1.6 mm
- Brazing wire: 1.0 to 1.6 mm
- Self-shielded wire: 1.0 to 1.6 mm
- Wire spool: 5 to 15 kg
- MMA electrode: 1.6 to 5.0 mm
- Protection rating: IP23S
- Weight of machine / set: 29.5 / 35 kg
- Dimensions (L x W x H): 820 x 270 x 530 mm
Features
Synergic mode
You set the material thickness and type and start welding. The arc control system matches the parameters step by step to the welding position and the material. You can correct the arc length manually and adjust the look of the weld to your needs.
Single and double pulse
In MIG/MAG you have PULSE and DP (double pulse) modes. In these you also set the arc length in pulse, the arc length at start and end current, the pulse base current and the pulse time.
MIG MAN and MIG SYN modes
In manual and synergic mode you adjust gas pre-flow and post-flow, wire run-in, wire burnback, voltage correction, spot welding time, inductance, and current up-slope and down-slope. The torch trigger works in SPOT, 2T, 4T (latch for long welds), S2T or S4T mode.
TIG LIFT and MMA
In TIG LIFT you set the welding current, the current down-slope time, gas post-flow, 2T or 4T trigger mode and the material thickness. In MMA you have HOT START with adjustable time, and ARC FORCE.
JOB memory
The JOB function saves and loads welding settings. When you change gas or wire, you do not have to set up the machine from scratch.
Cooling and protection
The fan runs in NORMAL or SMART mode. In SMART mode it switches on only when needed, so less dirt gets inside. The machine has overload, overvoltage and undervoltage protection and works with a power generator (+/- 15%).
In the box
- MIG 36 welding torch with Teflon liner, 3 m
- Electrode cable, 3 m
- Earth cable, 3 m
- 2 aluminium rolls 1.0 to 1.2 mm
- Hose with quick coupler
36-month warranty under the manufacturer's warranty terms, door-to-door service with no transport costs on your side.
