EXPERT MIG 250 4X4 PFC is a microprocessor-controlled synergic inverter MIG welder. It welds MIG/MAG, FLUX, MMA and TIG Lift, and brazes galvanised sheet. Welding current is 250 A, supply 230 V. It suits maintenance work and car body repairs.
It welds stainless steel, carbon and low-alloy steel, and aluminium under inert gas, active gas or a mixture, and without gas on reverse polarity.
Specifications
- Power supply: 230 V, 50 Hz, single-phase, with plug
- Mains protection: 25 A
- Power: 7.8 kW
- Welding current range: 40 to 250 A (MIG/MAG), 10 to 250 A (MMA/TIG), stepless adjustment
- Duty cycle: 250 A at 60%, 195 A at 100%
- Steel and stainless wire: 0.6 to 1.2 mm
- Aluminium wire: 1.0 to 1.2 mm
- Self-shielded wire: 0.8 to 1.2 mm
- Brazing wire: 0.8 mm
- Electrode: 1.6 to 6 mm
- Wire spool: 15 kg
- Protection rating: IP 23
- Weight of machine / set: 27 / 32 kg
- Dimensions (L x W x H): 760 x 320 x 580 mm
Features
- Manual mode and 21 synergic MIG/MAG programs.
- Adjustment: gas pre-flow and post-flow, wire run-in, wire burnback, spot welding time and pause between spot welds, inductance, voltage correction, soft start.
- Operating modes: 2T, 4T and spot welding.
- Parameter memory: when you change gas or wire, you do not set up the machine again.
- 4-roll wire feeder: copes well with torches 5 m long.
- PFC (Power Factor Correction): higher power factor and 30% lower current draw from the mains.
- Protection: overload, overvoltage and undervoltage. Works with a generator (+/- 15%).
- Cooling: fan.
Included
- MIG 24 torch, 3 m
- Earth cable, 3 m
Warranty
12 months for professional use, door-to-door service with no transport costs.
